Is There P2CMS for a PowerMac G5?

DGW

DGW

Well-known member
Just looked on Panasonic P2 Asset Support web site when registering my HVX200A and it seems the P2 viewer and P2CMS is for intel Mac only, not a PowerMac. Is this correct? Is there a different version I need for my G5? Any help appreciated.

Since I wrote the above I did further digging on the site and it seems P2 Viewer and P2CMS IS NOT AVAILABLE for a PowerMac. It is for INTEL MAC only. If this is not correct, can somebody please let me know? Thanks!
 
Last edited:
It is NOT correct. Just download it anyway. It works just fine. I have have a Powermac G5 dual and it works perfectly. When I installed it the site said the same thing. Just make sure you get the drivers as well. It will not work without the correct drivers that go with the App.
 
filthrich said:
It is NOT correct. Just download it anyway. It works just fine. I have have a Powermac G5 dual and it works perfectly. When I installed it the site said the same thing. Just make sure you get the drivers as well. It will not work without the correct drivers that go with the App.
Click to expand...
Thanks for the tip. I downloaded the supposed "intel mac" only version 1.4.4 and it did work flawlessly. I did not need to install any drivers...all my clips were immediately recognized. The included P2 viewer also played each one fine. I am using a dual PowerMac G5 2.5 ghz and my HVX200A system software is 4.8.0....I could not find anything on the site that showed a version above 4.6.0 but anyway, all seems to be fine. Thanks again!
 
You must log in or register to reply here.
Back
Top