Why am I getting "NO Valid Picture to Play" after trying to install Firmware?

I've hacked my firmware once before about a month ago. As I recall, I checked both boxes in the PTool. (Version increment and Prevent version compare)

When I check my firmware on the camera, I get 0.0.0

Yet still whenever I make any .bin firmware, place it on my SD card, and boot my camera, I get the "No Valid Picture to Play" on the screen after I hit the Play button.

I've even tried to go back to the factory default .bin file supplied on Panasonic's website, and still receive the same message.

Any ideas?
 
I was actually able to finally get it to re-flash with firmware ver. 1.22, but still unable to get any response out of any hacked .bin file.
(File names GH1__133.bin through GH1__140.bin and even trying increments 1 through 11 using PTool )

I'm stumped
 
Disregard my inquiry. I was doing something stupid and trying to hack the firmware for the GH1 instead of my GF1.
*head desk*
All is good. I figured I'd leave my posts just in case someone else does the same thing.
 
thekwijibo said:
I've hacked my firmware once before about a month ago. As I recall, I checked both boxes in the PTool. (Version increment and Prevent version compare)

When I check my firmware on the camera, I get 0.0.0

Yet still whenever I make any .bin firmware, place it on my SD card, and boot my camera, I get the "No Valid Picture to Play" on the screen after I hit the Play button.

I've even tried to go back to the factory default .bin file supplied on Panasonic's website, and still receive the same message.

Any ideas?
Click to expand...


Were you ever able to figure this out? I'm having the same problem.
 
You must log in or register to reply here.
Back
Top