USB or Firewire port?
- Thread starter dan traub
- Start date
Barry_Green
Moderator
If it's Windows, use USB Device mode. If it's a Mac, use 1394 Device mode.
I tried that
I tried that
THANKS BARRY--SINCE THEN i'VE BEEN DOING PR--BUT NOW I HAVE A NEW PROJECT TO EDIT. I USE A PC AND SONY VEGAS. STILL HAVE NEVER OFFLOADED TO MY pc. I OFFLOADED TO MY LAPTOP'S PCICIA SLOT SINCE THEN, BUT THAT WAS IN THE FIELD. NOW I'M AT HOME AND I WANT TO OFFLOAD TO MY pc, BUT WHEN I HOOK UP VIA USB, THE COMPUTER DOESN'T SEE THE CAMERA OR THE p2 CARD. BY THE WAY I DO HAVE p2 VIEWER INSTALLED ON THE pc. BUT NO LUCK SO FAR. I DON'T WANT TO HAVE TO USE THE LAPTOP.
THANKS
DAN
I tried that
THANKS BARRY--SINCE THEN i'VE BEEN DOING PR--BUT NOW I HAVE A NEW PROJECT TO EDIT. I USE A PC AND SONY VEGAS. STILL HAVE NEVER OFFLOADED TO MY pc. I OFFLOADED TO MY LAPTOP'S PCICIA SLOT SINCE THEN, BUT THAT WAS IN THE FIELD. NOW I'M AT HOME AND I WANT TO OFFLOAD TO MY pc, BUT WHEN I HOOK UP VIA USB, THE COMPUTER DOESN'T SEE THE CAMERA OR THE p2 CARD. BY THE WAY I DO HAVE p2 VIEWER INSTALLED ON THE pc. BUT NO LUCK SO FAR. I DON'T WANT TO HAVE TO USE THE LAPTOP.
THANKS
DAN
Barry_Green
Moderator
You have to install the drivers from Panasonic's P2 support page.
https://eww.pavc.panasonic.co.jp/pro-av/support/cs/csregistp2m/ep2main/
https://eww.pavc.panasonic.co.jp/pro-av/support/cs/csregistp2m/ep2main/
Leo Versola
Well-known member
After you install the drivers, make sure the camera is set as a USB device and not a 1394 device. Also, make sure you are putting the camera in PC mode not the recording or reviewing modes.
Cheers,
Cheers,