Stopped recording with new ML

T

tackyattack

Active member
So, when I tried setting the Qscale to -16 on my T2i with magic lantern(december build) installed it recorded fine without stopping. I recently updated to a new build of magic lantern(February 07 build) and now when I try recording with -16 it stops almost immediately, I even tried -13 and it still stopped. :huh:

Here is my memory card it's a Transcend 32 GB Class 10 SDHC Flash Memory Card:
http://www.amazon.com/dp/B003VNKNF0...e=asn&creative=395093&creativeASIN=B003VNKNF0

:dankk2:
 
Last edited:
Did you format the card recently?

Remember that frequently deleting and replacing files on the card with fragment the memory which negatively impacts speed. All too often I think people just delete the old ML files and place the new ones without formatting the card ever. It will get slower and slower the more you do this until you finally format it again.

See if that helps?
 
dishe said:
Did you format the card recently?

Remember that frequently deleting and replacing files on the card with fragment the memory which negatively impacts speed. All too often I think people just delete the old ML files and place the new ones without formatting the card ever. It will get slower and slower the more you do this until you finally format it again.

See if that helps?
Click to expand...
That was it! Its working again!!!
THANK YOU SOOOOOOO MUCH!!!!
 
DDirector said:
Does formatting off the camera to delete videos & pics delete the ML?
Click to expand...

Unfortunately, yes. Any kind of formatting sets the card back to the way it was from the factory.

Luckily, putting it back is very simple. Before you format, copy the ML files (including the .cfg file that contains your saved settings) into a directory on your computer.
Then, when you format, just use the utility to make it bootable and copy the contents of that directory to the root of your card. Takes about 10-20 seconds.
 
You must log in or register to reply here.
Back
Top