P2 clip - timecode reset to zero after 24hrs - need help

T

txiong

Member
I shot a 19min clip on the P2 card (480p)...I had an error transferring clip using FCP, then realized the starting timecode of clip was 23:58:30...once it hit 24hours, the timecode resets to zero half way through my clip, causing an error.

I was able to transfer the footage up the 24hr mark by setting the in and out points. I need the footage after the 24hr mark and can't seem to get it even if I set the in point after the zero mark to the end of the clip.

Anyone run into this issue before? Any help is appreciated.

Thanks.
 
Never experienced that problem....what settings are selected in your camera for timecode operation?
 
You must log in or register to reply here.
Back
Top