HVX as a P2 drive/reader

[jonnyh1968]

I want to use the HVX as a P2 reader so i can drag the files over to my G5 (via 1394). How do I do this? Searched everywhere and I can't find a thread.

 

[jonnyh1968]

figured it out by reading the manual.

!) Mac On
2) plug 1394 into camera
3) camera On
4) push mode button to switch to MCR mode.
5) Hold the "mode" button down again except this time for two seconds.
6) Mac should automatically recognize the HVX and mount it as a disk image.

 

[earthling]

figured it out by reading the manual.

!) Mac On
2) plug 1394 into camera
3) camera On
4) push mode button to switch to MCR mode.
5) Hold the "mode" button down again except this time for two seconds.
6) Mac should automatically recognize the HVX and mount it as a disk image.

THANK YOU !

I read the manual, but didn't see this info. Essential !

In my opinion, this should be set at the head of the workflow section.

Cheers,
Damien