We had our test today.
The HS400a mixer is excellent. 10 bit signal processing, lots of features and flexibility, easy to learn and setup.
What surprised us in a good way was how well the HPX300 performed in low light. After setting the gain properly (the factory setting was way to high)
there was little to no noise in the truly dark areas of the stage. It
exceeded our quality standards for live capture. Colors were accurate and no breakup when the pastor went up on stage wearing a multicolor plaid shirt.
In the worst case scenario, we completely turned off the lights over the congregation area, and had low power color pars and one source 4 spot on the stage covering 2 people, 1 playing drums, the other the piano.
Honestly, the quality of the footage looked like something you would see on the Tonight Show or Conan Obrian. I am not exagerating on this.
As expected..zero IR contamination and no CA with the kit lens.
We shot both in 1080i and 720x60p (preferred format). No rolling shutter issues, since we know how to pan our cameras.
We had a professional Panasonic HDSDI monitor hooked up to the mixers preview output (preview up to 10 inputs) so we didn't rely on low end consumer equipment for testing.
For comparison Dom Cicchetti brought along a remote control pan and tilt camera that used the same chipset/lens as the HVX200. IR, and lots of noise showed up under the same conditions. But at least it gave us something to compare to.
What we didn't do was completely optimize the camera for our environment, and it still looked awesome.
Before this demo, because of all the negative info swirling around the internet we did not consider this camera at all. After, I'm confident that if we decide to purchase, it will meet or exceed our needs.
While the EX3 is slightly better in low light, the HPX300 camera is superior in every other category you can think of (that truly matters). It has broadcast features that are expensive add ons for the EX3. Plus having a longer lens means we don't need to replace it or add a tele extender like we would have on at least one of the EX3s. (This is based on our current church layout).
Being able to record 10bit 4:2:2 directly to the P2 media means we don't need to haul around the AJA IO HD and a laptop to get best quality. Built in Scopes and waveform monitoring is a plus, also.. something I didn't know until today, built in tally support when using supported cables from Panasonic.
Let me say again. This camera perfoms great in low light when set up properly.
Note: 1080 24p is not a format we will use during services. But it's cool to have that option for video skits.
Any churches or educational institutions looking to upgrade to HD, you owe it to yourselves to check out this camera. Don't let the internet naysayers (many who have never actually used the camera) carry any weight with your decisions.
I want to thank Pansonic and Dom Cicchetti and the mixer/camera expert he brought with him to the demo . (Sorry I forgot his name).
Joe Carney
The HS400a mixer is excellent. 10 bit signal processing, lots of features and flexibility, easy to learn and setup.
What surprised us in a good way was how well the HPX300 performed in low light. After setting the gain properly (the factory setting was way to high)
there was little to no noise in the truly dark areas of the stage. It
exceeded our quality standards for live capture. Colors were accurate and no breakup when the pastor went up on stage wearing a multicolor plaid shirt.
In the worst case scenario, we completely turned off the lights over the congregation area, and had low power color pars and one source 4 spot on the stage covering 2 people, 1 playing drums, the other the piano.
Honestly, the quality of the footage looked like something you would see on the Tonight Show or Conan Obrian. I am not exagerating on this.
As expected..zero IR contamination and no CA with the kit lens.
We shot both in 1080i and 720x60p (preferred format). No rolling shutter issues, since we know how to pan our cameras.
We had a professional Panasonic HDSDI monitor hooked up to the mixers preview output (preview up to 10 inputs) so we didn't rely on low end consumer equipment for testing.
For comparison Dom Cicchetti brought along a remote control pan and tilt camera that used the same chipset/lens as the HVX200. IR, and lots of noise showed up under the same conditions. But at least it gave us something to compare to.
What we didn't do was completely optimize the camera for our environment, and it still looked awesome.
Before this demo, because of all the negative info swirling around the internet we did not consider this camera at all. After, I'm confident that if we decide to purchase, it will meet or exceed our needs.
While the EX3 is slightly better in low light, the HPX300 camera is superior in every other category you can think of (that truly matters). It has broadcast features that are expensive add ons for the EX3. Plus having a longer lens means we don't need to replace it or add a tele extender like we would have on at least one of the EX3s. (This is based on our current church layout).
Being able to record 10bit 4:2:2 directly to the P2 media means we don't need to haul around the AJA IO HD and a laptop to get best quality. Built in Scopes and waveform monitoring is a plus, also.. something I didn't know until today, built in tally support when using supported cables from Panasonic.
Let me say again. This camera perfoms great in low light when set up properly.
Note: 1080 24p is not a format we will use during services. But it's cool to have that option for video skits.
Any churches or educational institutions looking to upgrade to HD, you owe it to yourselves to check out this camera. Don't let the internet naysayers (many who have never actually used the camera) carry any weight with your decisions.
I want to thank Pansonic and Dom Cicchetti and the mixer/camera expert he brought with him to the demo . (Sorry I forgot his name).
Joe Carney