[FS: General] Wooden Shoulder Rig

[Daniel Abdilla]

Hi Guys, I'm selling my wooden shoulder rig. This is the same as the ergocine lion. This beauty makes life easier for in all the aspects: Shoulder, mounting points, ergonomic hand positions and perfect for mounting viewfinder at eye position. Plus it looks gorgeous. The top arm is perfect for hand held too.

This design is based on the Aaton XTR camera and will take any DSLR in the market, BMCC, C100/C300/C500 to a whole new level of ergonomics.


Includes:

• Standard 15mm rails front and back (front 12", back 6")
• 2 Ball handles and a trigger with connection ready for LANC remote
• Internal grooves for neat wiring
• 6 1/4" thread mounting points for accessories
• Shoulder cushion pads
• Mahogany finish
• Standard base-plate included

I rigged mine with some basic equipment (D800, mic, 5.6" monitor, back battery..) and worked wonders. The switch on the handle can be connected to any LANC camera/hardware cause it uses simple 3.5mm connection(you just have to use a custom cable).


My setup on it (minus the Nikon D800) (more pictures on link below)


It's currently on Ebay for auction ( http://www.ebay.co.uk/itm/171481354423?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649 ).
If anyone from this forum wants to buy it with a good offer, I'm willing to stop auction and directly sell it to you (safely through ebay).

Selling for 700$ or best offer.

If bought new, this cost above 1300$.

Thanks!