What am I doing wrong?!?!

G

Gladiator

Well-known member
I just started using Cineform Neoscene and my footage looks awesome and runs silky smooth. I just have one BIG problem, the audio is just alot of loud blips! What on earth am I doing wrong? Any help would be appreciated. Thanks in advance!
 
sounds like you don't have the proper ac3 plugin installed. Below is from the cineform support site:

"NOTE about Audio: If you are not properly converting audio, you may not have an AC3 decoder installed. Many software packages install an AC3 decoder, but if not, you can get a free AC3 decoder here: http://www.free-codecs.com/download/ac3_filter.htm."

install this free plugin and your audio should play back correctly.

Ed
 
Edweirdo said:
sounds like you don't have the proper ac3 plugin installed. Below is from the cineform support site:

"NOTE about Audio: If you are not properly converting audio, you may not have an AC3 decoder installed. Many software packages install an AC3 decoder, but if not, you can get a free AC3 decoder here: http://www.free-codecs.com/download/ac3_filter.htm."

install this free plugin and your audio should play back correctly.

Ed
Click to expand...

That was it! Thanks a whole bunch Edweirdo!
 
i was very pleased when i read this thread as i have the same problem. however, mine only does it to every 1 out of 5 (on average) clips. if my problem was a missing decoder then surely it would do it to every clip..........right?
 
igetcha said:
i was very pleased when i read this thread as i have the same problem. however, mine only does it to every 1 out of 5 (on average) clips. if my problem was a missing decoder then surely it would do it to every clip..........right?
Click to expand...

IDK, the first clip was fine, after that was the really ugly noise.
 
You must log in or register to reply here.
Back
Top