This is a well used but still strong Vinten Vision 10 tripod including head, 2-stage sticks, and spreader. This was originally an ENG kit that retailed around $3500. It has seen a lot of use and here is a list of issues:
-head tightening handle is partially broken -- still functions but missing half the handle -- replacement is ~$40 from B&H
-metal finger ring on spreader bar is gone, little plastic tab that would retain it is broken
-the sticker on one side has fallen off (shown in pictures)
-head is low on fluid, noticeable in certain climates, could use a servicing probably $200-300. When tilting up and down, there is a point at which the low fluid becomes obvious when it has a subtle notch at extreme angles. Panning is great and 90% of all tilting is great.
Payload up to 32lbs.
bubble level
Height 16.4"-61.5"
Fluid head
100mm bowl
Thus the price is 900 shipped OBO
-head tightening handle is partially broken -- still functions but missing half the handle -- replacement is ~$40 from B&H
-metal finger ring on spreader bar is gone, little plastic tab that would retain it is broken
-the sticker on one side has fallen off (shown in pictures)
-head is low on fluid, noticeable in certain climates, could use a servicing probably $200-300. When tilting up and down, there is a point at which the low fluid becomes obvious when it has a subtle notch at extreme angles. Panning is great and 90% of all tilting is great.
Payload up to 32lbs.
bubble level
Height 16.4"-61.5"
Fluid head
100mm bowl
Thus the price is 900 shipped OBO
Attachments
Last edited: