UX180 and UX90 new firmware

UX90 Improvements:
On rare occasions, the operation of REC button on the unit or a wired remote control may no longer have any effect. This problem is fixed.
If the card is ejected from the main slot during the simultaneous recording, the recording in the sub-slot stops 10 hours after the start of recording. The indication shows the same as during recording, and the operations of REC button are refused. This problem is fixed.
LCD may not show anything when the camera is booted up. This problem is fixed.
A very few SD cards may have a write error. This problem is fixed.
If the network address is changed when WIRELESS SETUP is set to [DIRECT] and DHCP is set to [SERVER], it sometimes made the camera impossible to connect to the iPad. This problem is fixed.
 
The above write-up is from 2018, Version 1.08.

Was actually shocked - from a business standpoint - why in the world they would support this camera this late, but they didn't.

This recent update is 1.14 and it's a, "This update is to improve efficiency of production." update.
 
You must log in or register to reply here.
Back
Top