Unidentified Artifact

seanmcleod

seanmcleod

Well-known member
Hey guys, I'm sure this issue is probably been brought up before but I'm not sure what exactly to call it so I can't really find it in a search. I'm wondering if there's anything that can be done about those little vertical lines, they almost look like splices, that appear in GH1 footage. It looks a lot like an interlaced artifact left behind or something. Is this part of what happens when shooting fast motion, or is it something with encoding.

Okay, so I just tried to take screen grab of what I was talking about to show you but when I go frame by frame I can't see it, and it doesn't seem to be present in the same place necessarily every time, or my eyes just don't catch it every time.

Watch this film at around the 2:55 to 3:03 mark... right when the elevator door is about to close you can see it... it looks like little cuts in the footage...

http://vimeo.com/7927504

What's up with that?
 
You're referring to the screen tearing issue. It's not an issue with your footage. It's an artifact of your video card rendering the Flash video on the Web page. How to make it go away? Get a new video card and install the Flash Player 10.1 beta, which has GPU acceleration for Flash video.
 
Last edited:
I do see it when cutting in FCP as well though... is it still just because the stock card on my macbook pro isn't up to snuff?
 
Basically what you see is the frame rate of the video you playing out of sync with the refresh rate of the video card and screen. The frame changes during a refresh and you see half of two frames. I see it as well on my computer screen but as I use a broadcast monitor fed by a Blackmagic Design capture and playback card for dead-sync editing I don't look much at the viewer and canvas. Sometimes I even close them and have a huge vertical timeline when the layers start to stack up - especially for audio editing.
 
seanmcleod said:
I do see it when cutting in FCP as well though... is it still just because the stock card on my macbook pro isn't up to snuff?
Click to expand...
Yes.

As long as you don't see the artifact when going frame-by-frame, then there is no problem at all in the footage. Common sense.
 
You must log in or register to reply here.
Back
Top