timecode error in batch capture

[pablogott]

I have been having the same problem for months now. When I try to import more than one clip after logging an entire tape I always get a message:

"Batch Capture: Timecode Error: Unable to locate the specified timecode. You may have specified timecode with insufficient room for pre/post roll operation."

A quick search through google pulls up several beginners having this problem (I am a beginner also).

I have a g5 running Final Cut Pro 5. I am using a Sony DCR-HC30, and have had the same problem with my Sony HDR FX1.

I am not trying to capture near the beginning of the tape. If I batch capture one clip at a time, it usually works, but sometimes it captures the wrong thing.

Is there a timecode setting on my camera that could be wrong? Is it common to see this error?

It is possible I am logging wrong. I play the tape, hit the "I" key when I want it to start, and the "F2" key to set the out point and to label it. After I get about 30 clips logged, I select "batch capture."

I could do a capture now -that works fine, but I have a lot of footage and want to conserve hard drive space. Any suggestions at all would be much appreciated.

 

[Scottdvx100]

Press rec check button between powering off or reviewing.

More than likely your timecode reset to 0 so you have multiple spots on the tape with the same timecode.

Make sure to roll off a biut before the crtical ppart of the shot and continue to roll for a moment or two when done with a take. Keep in/out capture points inbetween starting and stopping camera points.

 

[pablogott]

wow, you have no idea how long i have been trying to figure that out. that sounds like it is very likely the problem, since we often review footage and fast forward to a blank spot. thanks a lot for the help.