FS7: Suggestions for camera settings using a6300s as B- cams

P

PMP1115

Member
Hi all,

I'm shooting in a studio against a white cyc, a multi-cam video using FS7 and two a6300's. I was wondering if anyone could offer up some advice on how best to match the cameras together.

my initial thought was to set every camera to slog3.cine and that would make it easy.

However, after shooting a quick test in my home, i noticed that the a6300 footage was really noisy... probably due to the lower quality, 8-bit internal recording settings of the a6300. This could possibly be remedied by recording HDMI out into a my Shogun Flame. I only one have shogun, and one of the a6300s is supposed to be on a handheld gimbal for some special shots, making it kind of a pain to have attached.

Being in a controlled studio environment doesn't really call for SLOG3- so does anyone have any suggestions on how I could go about matching these cameras up?


Much appreciated!


-Percy
 
I had an A6500 that I wanted to use as "B" camera for my FS7, but ended up sending it back because of overheating issues in 4K. In my notes I found this: "Cinegamma 1 is the same as Hypergamma 4". Hope that helps.
 
I use an a6500 as my B camera, never noticed any noise problems or overheating.

I’ve used the Cinegamma 1/HG 4 a few times with success. I’m still looking for the ideal match without having to use s-log.
 
gkantziper said:
I had an A6500 that I wanted to use as "B" camera for my FS7, but ended up sending it back because of overheating issues in 4K. In my notes I found this: "Cinegamma 1 is the same as Hypergamma 4". Hope that helps.
Click to expand...

Thank you, that is very helpful. I'm to be receiving an 6300 to experiment with shortly and will give that a try!
 
it depends what you are shooting on the FS7

I had the a6300 for a while and with the FS7 CineEI on the a6300 Cine4 and color mode S-Gamut3 Cine was a pretty good match.
 
You must log in or register to reply here.
Back
Top