I just recently purchased this camera used with less than 10 hours on it.
When I go to power the camera on, the power switch seems to take a lot of pressure to get it to go to the on position. It acts as though there is something blocking it, or locking it to the off position and I have to force it past that point, and again past that point when I power it down.
Before I break something because of my inexperience with this camera, can you tell me if this is normal or am I neglecting a step in the "powering on" procedure ???
Thanks in advance.
My Bad..... read the manual and found the lock portion of the power switch.
When I go to power the camera on, the power switch seems to take a lot of pressure to get it to go to the on position. It acts as though there is something blocking it, or locking it to the off position and I have to force it past that point, and again past that point when I power it down.
Before I break something because of my inexperience with this camera, can you tell me if this is normal or am I neglecting a step in the "powering on" procedure ???
Thanks in advance.
My Bad..... read the manual and found the lock portion of the power switch.
Last edited: