FS7: Split clips concatenation?

moldcad

moldcad

Veteran
With my EX1 - when off-loading SxS cards to my hard drive - I used the Content Management utility, and one of its advantages was the ability to concatenate slips split over 2 cards into one, complete take. Is the same possible using Catalyst Browse?

Sorry for creating separate threads with my newbie questions, but I see my original large thread has got buried down below newer (and more interesting for advanced community here) ones. TIA for an answer to this!

Piotr
 
Yes!.. Catalyst Browser will do the same thing if both cards contents are placed in the same destination folder.
 
You must log in or register to reply here.
Back
Top