simple capture question needing help

S

spratrbo

Member
I have tried to capture the mxf files every single way to sundown and I am still getting error messages so I am hoping this is a simple solution.

Using FCP 5.0.1 on a dual 2.5gig

I have various test footage in 720p from 24p to 30pn and I am following the directions to get the computer to link with the camera. The computer recognizes the camera and sees it as a removeable drive. I fire up FCP and try the P2 capture. It sees the files or at least the .bmp files and then I get an error msg stating the files are corrupt. I have tried dropping the files straight into the hard drive and again FCP sees the files but says they are corrupt. I have tried the "log and capture" method and that is no good either. Perhaps it is just late and my being tired is making me stupid, but a helpful hint in the right direction would be most appreciated.

Thanks

JP
 
If this is the case then why is there a P2 capture option on my version? And I was also reading another post where someone was getting the same error message as me saying the files were corrupt when trying to import from the hard drive. Any suggestions.

JP
 
You must log in or register to reply here.
Back
Top