Sennheiser MKH 415T

Yoji san

Yoji san

Active member
SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD

100% working Sennheiser MKH 415T

The classic Hollywood sound...
Those microphone were build to last and will survive anything. For example, if you had to record sound in a humid environment, If you are shooting in a high RF place like New York City, don't look any further this is your MIC to go!
It is internally exactly the same as the Sennheiser MKH416T and is powered by 12V (not phantom power)
I am asking $500 (+Shipping)

MKH1.jpg


MKH2.jpg


MKH3.jpg



Here are the specs:
Transducer
Pressure Gradient/Interference Receiver Condenser
Polar Pattern
Supercardioid/Lobar
Frequency Response
40 Hz - 20 kHz
Dynamic Range (Typical)
117 dB
Signal-to-Noise Ratio
81 dB
Maximum Input Sound Level
130 dB, (@ 1 kHz)
Power Requirements
T-Power 12v, (± 12v)
Output Impedance
Nominal Impedance: 25 Ohms
Minimum Terminating Impedance: 800 Ohms
Output Connectors
XLR-3M Type
Pad
None
Low Frequency Roll-Off
None
Applications
Film, Radio and Television, Especially for Outside Broadcast Applications.
Dimensions
9.84 x .74 (250 x 19mm) LxD
Weight
5.82 oz. (175 g)
 
Last edited:
You must log in or register to reply here.
Back
Top