Running SDI and HDMI out with S-log?

S

simonmountney

New member
Hi all, I was wondering if it's possible to run the Sony F3 with S-log turned on and have both SDI and HDMI out? I use a Zacuto EVF Viewer (HDMI), and have an additional monitor which we use to view things in set through SDI. However with S-Log switched on it seems that the option for simultaneous viewing of both has been taken away, it's either one or the other. Is there a working solution for this issue?

Cheers

Simon
 
You could always run SDI+HDMI simultaneously with dual link off. That remains the case now. In fact, with 1.31 firmware, things are vastly improved because you can take either a 444 dual link/3G or a 1.5g 422 signal from the dual link ports while aving either your sdi or hdmi active. And you can apply a viewing LUT to the SDI/HDMI output should you so choose.
 
You must log in or register to reply here.
Back
Top