I'm having a weird situation. I rotoscoped some footage of a soldier typing on a hologram beacon (that I created inside after effects) so that it looks like his fingers are touching it. When inside AE it looks fine, but after I export it you can clearly see his hands going through the hologram beacon as if the rotoscoped work did not export. Am I missing something?
Rotoscoping not showing up on export?
- Thread starter FilmBoy77
- Start date
Are you exporting to a different image dimension from the composition?
Hawk Teflon
Veteran
Can you export a 720 or 1080 version so I can see what you're talking about?
No prob.
Here is what it looks like inside the layer view: http://goo.gl/ADfoYB
Here is what it looks like in the comp view: http://goo.gl/tQH55c
And here is what it looks like once it's rendered (you can see the finger going through the hologram):http://goo.gl/8DvO54
The camera view is in Active Camera view also.
Here is what it looks like inside the layer view: http://goo.gl/ADfoYB
Here is what it looks like in the comp view: http://goo.gl/tQH55c
And here is what it looks like once it's rendered (you can see the finger going through the hologram):http://goo.gl/8DvO54
The camera view is in Active Camera view also.
Hawk Teflon
Veteran
Peculiar. So it acts correctly in AE, but only on render does it cut off like that? Basic questions:
Is the mask layer large enough?
Is the mask keyframed?
This is not a track matte, correct?
Is there a linear wipe on that mask layer?
Are there any effects on the mask layer?
Is it ever correct, or cut off the whole time?
Can you render a short clip of it happening?
Is the mask layer large enough?
Is the mask keyframed?
This is not a track matte, correct?
Is there a linear wipe on that mask layer?
Are there any effects on the mask layer?
Is it ever correct, or cut off the whole time?
Can you render a short clip of it happening?