Problem loading 10 hour clip into FCP

D

dcsimages

Member
Hi all

I set up an HVX 200 shooting 720/30N with 2 16GB P2 cards locked down and running continuously to use as timelapse footage.

I recorded about 10 hours of footage, downloaded the cards to an external drive via the Panasonic 5 slot reader, USB version and a Macbook Pro using the P2 content management software.

The clip in question is about 10 hours long and I can see all of it start to finish in content manager.

The client has the footage and is doing a rough cut.

When trying to bring the clip into Final Cut the last hour of the clip is missing.

Of course that's the most important section of the clip.

Any help would be appreciated.

Dave
 
in the log and transfer window do you see that last hour there, and it's only missing after you L&T, or is it missing there too?
 
Client has the footage, so I'm trying to do this over the phone with him.

He imported project using file import.

I just had him try log and transfer and he's getting the same result.

He dragged the clip to the timeline and it's truncated.
 
Just got off the phone with the client again.

The clip is only 1:42 minutes long. He misread the time code.

It's getting cut off about half way through.

He's on Final Cut 6.05 if it makes any difference.
 
You must log in or register to reply here.
Back
Top