P2 Store and Mac

K

KWR

Member
Does anyone use a P2 Store with a Mac? Please tell me how to access the footage I've dumped to the P2 Store. When I hook it up to my computer no drive shows up, I've gone through the installation process but no software shows up on my computer. I've tried it several times. Thanks. You could call me if you know at 541 490-5666
Here's some footage I've shot with the camera so far:
http://www.kidswhorip.com/videos/lucas_hudson.mov
 
You have to turn the p2store onto the mac setting. You hold down 3 buttons to do it... It's mentioned on this forum and also on the panasonic site... Do a search and you'll find it out... I did it and was very easy to pull off...
 
You need to set the P2 Store to Mac mode. Hold both the Batt. button and HDD Cap. button for like five or more seconds. When the led changes from green to orange your in MAC mode. Then the drive will mount. It will look like many different drives though. Each card will mount as it's own drive even though it's all coming off the P2 store.
 
This is how it ended up working for me:

Hold in the HDD CAP button, the CANCEL BUTTON and the BATTERY TEST BUTTON
for more than 5 seconds. The USB light turns from green to orange. This
means that you are now in the Mac mode.

Make sure you hold all of those buttons in at the same time. You should only
have to do this the one time.
 
You must log in or register to reply here.
Back
Top