I am new to the GH1 and AVCHD but not to Final Cut.
I have searched through the forums here but can't seem to find the answer to my question so here goes:
When I go to Log/Transfer in FCE 4.0 my clips from my GH1 show up. But when I bring a clip down into the queue to transfer the problems start. The clip goes idle after a bit and then shows an error under 'Status'. When I scroll over the the Status is says "Error: No Data."
My clips are 720 60p. And maybe that's the big issue. FCE doesn't have a codec listed for 720 60p only 720 30p or 1080 60i. I didn't think I would have to change my codec if I wasn't shooting in 24 but I may be very wrong.
Can anyone please help?
I have searched through the forums here but can't seem to find the answer to my question so here goes:
When I go to Log/Transfer in FCE 4.0 my clips from my GH1 show up. But when I bring a clip down into the queue to transfer the problems start. The clip goes idle after a bit and then shows an error under 'Status'. When I scroll over the the Status is says "Error: No Data."
My clips are 720 60p. And maybe that's the big issue. FCE doesn't have a codec listed for 720 60p only 720 30p or 1080 60i. I didn't think I would have to change my codec if I wasn't shooting in 24 but I may be very wrong.
Can anyone please help?