FS700 Camera Info on Odyssesy 7Q

J

jamesc

Well-known member
Very sorry if this has been answered before. Is it possible to have the Display Info data on the 7Q? I've turned on DISPLAY OUTPUT to ALL OUTPUT on the FS700, but still see nothing. I know this works over HDMI with my Zacuto Viewfinder. Also tried turning off CENTER MARKER (which works sometimes), but still nothing.

Tried looking through the manual and quickstarter guide, but nothing was mentioned.
 
It won't output it over the top of the raw signal. I expect you have the camera set to output Raw, swap it back to HD and it should all be there. Or use the HDMI input.
 
If you are sending a RAW signal to the Odyssey7Q, there is no display info in the feed. The HDMI port on the camera is still active and it will continue to carry the display info if you have it activated.

In the future, we will allow inputting of multiple HD signals with one being recorded while another is viewed on the monitor. Note that this is not for use with a RAW feed, only HD. In this mode, you could record the clean signal while viewing the second signal with it's display info. We refer to this as an engineer's mode, as it is assumed to be for a DIT or video engineer who needs to monitor the menus.

If it is possible for us to handle accepting a RAW signal while monitoring a second HD signal then we will implement that as well. On the FS700 that would mean RAW input over SDI and HD with menus via HDMI.
 
You must log in or register to reply here.
Back
Top