Rocket_Dog
Active member
$450 - EZ-Slider 32.5 inch multi-functional Linear Slider system. It's about 6 months old and in excellent condition.
It's almost identical in design to the DP slider but I prefer this one since it's much more low profile and a less dangerous for little kids running around than the DP slider when tripod mounted. The feet are also much better than the DP slider.
features:
The versatility of the E-Z Slider will make it a favorite tool for your film, event and corporate productions. Check out the features of the E-Z Slider.
- 3/8" tapped center hole for direct mounting to a tripod or attaching a quick release adapter plate. 1/4" tapped hole so quick release plate can be attached with two screws.
- 3/8" and 1/4" tapped holes in end plate for mounting to a tripod or to attach a quick release plate in vertical mode.
- E-Z Slider mounted vertically on a tripod with a quick release plate. Simulate crane motion in vertical mode.
- Non-marking rubber feet and 3/8" tapped hole for light stand adapters
- Carriage with permanently lubricated ball bearings, rubber bumpers and brake.
http://www.ambientsky.com/sale/all/Images/29.jpghttp://www.ambientsky.com/sale/all/Images/28.jpg
Save over $100 off a new one.
http://www.e-zslider.com/store.html?page=shop.browse&category_id=7
It's almost identical in design to the DP slider but I prefer this one since it's much more low profile and a less dangerous for little kids running around than the DP slider when tripod mounted. The feet are also much better than the DP slider.
features:
The versatility of the E-Z Slider will make it a favorite tool for your film, event and corporate productions. Check out the features of the E-Z Slider.
- 3/8" tapped center hole for direct mounting to a tripod or attaching a quick release adapter plate. 1/4" tapped hole so quick release plate can be attached with two screws.
- 3/8" and 1/4" tapped holes in end plate for mounting to a tripod or to attach a quick release plate in vertical mode.
- E-Z Slider mounted vertically on a tripod with a quick release plate. Simulate crane motion in vertical mode.
- Non-marking rubber feet and 3/8" tapped hole for light stand adapters
- Carriage with permanently lubricated ball bearings, rubber bumpers and brake.
http://www.ambientsky.com/sale/all/Images/29.jpghttp://www.ambientsky.com/sale/all/Images/28.jpg
Save over $100 off a new one.
http://www.e-zslider.com/store.html?page=shop.browse&category_id=7
Last edited:
