FS5: Error FS5 raw with new firmwire inferno 8.11

R

Robby Barus

Member
I test new firmwire Inferno 8.11 with FS5 RAW but Inferno can't record with new firmwire 8.11 monitor Inferno just blink Red
but before update with firmwire 8.1 its no problem, i use drive Sandisk Extreme Pro SSD 240GB, and i test with sony 7s i have same problem cant record

FS5 RAW.jpgInferno firmwire 8.11.JPG

Record with FS5 RAW

Record Manual with FS5 RAW
[video=https://www.youtube.com/watch?v=-Hc2aJx0ZDc&feature=youtu.be[/video]
 
Last edited:
Did you try downgrade? I still have somewhere 8.01 for that case.

But my Inferno works with fs700 without problems.
 
KrocanX said:
Did you try downgrade? I still have somewhere 8.01 for that case.

But my Inferno works with fs700 without problems.
Click to expand...

i dont have file firmwire 8.01 did you have? i searching in google file is missing.. by the way you use new firmwire in fs700
 
i have problem again firmwire 8.01 in my inferno cant not out signal video from sdi or hdmi setting camera is RAW FS5
if i setting XAVC from FS5 signal out sdi or hdmi from inferno its ok no problem
 
its now working i reinstal firmwire 8.11
and now problem signal video from SDI RAW inferno in my external monitor Blackmagic Video Assist 5 inch in display like a double picture (attach in photo) and try to my monitor type ViewZ VZ-185PM-P is blank (no signal)
but when i change camera setting XAVC (Not RAW) its working
 

Attachments

  • display monitor blackmagic via SDI.jpg
    display monitor blackmagic via SDI.jpg
    61.1 KB · Views: 0
  • display in shogun inferno.jpg
    display in shogun inferno.jpg
    74.7 KB · Views: 0
moldcad said:
Double picture (offset vertically or horizontally) usually means bad SDI cable!

Piotr
Click to expand...
hi piotr..
picture horizontal in display monitor blackmagic 5'
From Inverno to Blackmagic monitor 5' i use SDI Canare L-2.5CHD, Canare BNC to DIN and from Inverno to ViewZ monitor i use cable SDI Canare L-4CHD, Canare BNC to BNC
 
Piotr tried to say that you cable is bad - not good quality, damaged etc. You should try different cable.
 
KrocanX said:
Piotr tried to say that you cable is bad - not good quality, damaged etc. You should try different cable.
Click to expand...

hi kroncaX.. its imposible if my cable damaged, because when i change record setting XAVC in my camra its good signal out SDI/HDMI from inverno
 
You must log in or register to reply here.
Back
Top