DIY F35 Power Cable - 8 pin lemo to 4 pin xlr - diagram needed

S

Samana76

Active member
I'm trying to fabricate my own power cable to save ~$250.00 (http://www.markertek.com/product/rd...aa5cIc_msdM4CcZFq_N-kNTAgax9I4XYlAhoCKmHw_wcB). I have the two connectors, an 8 pin female 3B lemo and a 4 pin XLR male connector, and a few feet of cable. However I am need of the diagrams of each connector so that I can correctly solder the pins. Does anyone have a diagram that shows the power + - and ground of each connector? Has anyone here soldered their own and can share with me and the community any useful information?

Thank you all in advance.

Igor
 
I have, when I am home I will find the pin outs for you. The Lemo is a mare.

you have to wire six pins in it - three Pos three ground.
 
i'm sorry the readout is a little smudged. This is off the back of my AB plate. It's funny it only mentions F23 and F65 but it is definitely the F35 pinout also.

IMG_1887.jpg

you should make a few extras and sell them...
 
James, yachacha, thank you both so much for your help in this.

yachacha, that's not a bad idea. I'll see how this first one goes and then might consider making others for sale.

Have a great 4th of July, y'all.

Igor
 
Probably obvious but also be very careful what you then plug into - the camera draws 56W on its own, which isn't too much but the 8-pin LEMO will also feed power to the 12V accessory port if you are using that. So that's another 4a load, and if you were using the SRW-1 recorder too, you could be drawing up to 160+w from one battery, potentially...
 
You must log in or register to reply here.
Back
Top