Determining frame rate on playback

S

Stas_Tagios

Well-known member
Discovered in the middle of a shoot today that the scene file dial had been inadvertently turned from F6 to F5 at some point during or prior to the shoot (I normally shoot everything at F6).

Is there any way to determine which footage was shot at 24P and not 24PA (besides single-framing through a bit of every clip to see which pulldown pattern was applied)? I have screen display on "all", but on playback, "all" only seems to be the timecode, aperture, gain, and audio, not frame rate.

I'd like to avoid having to log all the clips with the wrong setting (e.g., logging clips to be captured as 24PA and discovering some were 24P) and have to fix it afterward.
 
If you had set your user bits to record frame rate it would show there, or if you use the camera for playback and put up the display characters it will show there.

Hope that helps,

Jan
 
Jan, thanks for the quick reply.

What do you mean by "display characters?" On playback, the info that I have displayed is F-stop, audio, gain, and timecode, but no frame rate. Is this different from the setting you're referring to?

I'll check my manual too. Thanks again!
 
You must log in or register to reply here.
Back
Top