FS7: Cannot Proceed

[egproductions]

On occasion I get the "Cannot Proceed" message when trying to enable certain features. For instance enabling peaking or zebras. It seems to be a glitch and not tied to any other setting. It then randomly goes away and I regain access eventually.

Is this a normal bug in firmware 2.0? Is there any reset/fix when the issue presents itself?

 

[Liam Hall]

Not seen that happen with peaking or zebras, were you in playback mode?

 

[Doug Jensen]

Did you have picture cache turned on? Zebras and peaking are disabled with picture cache.

 

[egproductions]

Did you have picture cache turned on? Zebras and peaking are disabled with picture cache.

That very well could have been it, thank you!

 

[egproductions]

I'm noticing that when switching to S&Q mode, the motion is very stuttery in the LCD. Playback is fine. I can't be sure but I believe I recall it not always being this way. DId I change a setting that would have caused this? Shutter speed is either 1/192 or 1/400.

I'm shooting 1080P at 23.976. cine EI sgamut 3 cine

 

[Doug Jensen]

Sorry, I can't think of anything on the FS7 that would change the way motion looks in the viewfinder during S&Q. If we were talking about an F55/F5 I'd say that you had accidentally turned off the viewfinder's Double Speed Drive mode, but the FS7 doesn't have that feature. Too bad, I wish it did. If you figure it out, let us know.

 

[ohtheview]

It is very annoying to get the "Cannot Proceed" message on the screen. It seems to me that they could tell you why just as easily.

 

[Ed Waters]

I had the shutter speed go to 1/192 when in set the slow mo to 180fps.