Jay Rodriguez
Coffee Member
Any feed back on it would be good to hear.
Ball head for crane/tripod... Ever see this one?
- Thread starter Jay Rodriguez
- Start date
Terry_Lasater
All about the Caption
That is made for still cameras... which are lighter than (most) video cameras... which are lighter than most jibs.
Oh well, I've already given my thoughts on your jib situation.
Oh well, I've already given my thoughts on your jib situation.
Jay Rodriguez
Coffee Member
I know you offered me some advice before Terry, thank you for that. I'm just trying to find a less expensive measure.
The ball head shown above supports up to 90 pounds. Are you sure about what you said regarding this being made for still camreas?
Look here:
http://www.adorama.com/AWMB138.html
The ball head shown above supports up to 90 pounds. Are you sure about what you said regarding this being made for still camreas?
Look here:
http://www.adorama.com/AWMB138.html
mikkowilson
Steadi-Guru
90lb??
how big is that thing coffee?!?
it looks like that's a locking accesory shoe (same size as hot shoe) on top..
- Mikko
how big is that thing coffee?!?
it looks like that's a locking accesory shoe (same size as hot shoe) on top..
- Mikko
Jay Rodriguez
Coffee Member
mikkowilson said:
Mikko,
It looks small right? I'm not sure how big it is. I'm going into NYC tomorrow morning to take a look at it. I REALLY need to find a way to mount my crane for a shoot this weekend so I've been on the hunt fo a solution.
Terry_Lasater
All about the Caption
If you can't do a smooth pan and tilt, then, yup, it's made for still cameras. It's most likely rated for cameras (up to) 8x10 view cameras.
Can you attach your crane/jib directly to a tripod without a head, then put the leveling head at the camera end of the jib?
Can you attach your crane/jib directly to a tripod without a head, then put the leveling head at the camera end of the jib?
Jay Rodriguez
Coffee Member
When I take the head off of the tripod, the top of the tripod has a half bowl with a hole in the middle that's about an inch wide.
On the crane, the provided piece that's meant to attach to the tripod is a flat plate with two bolts hanging off of it.
I'm getting frustrated with trying to figure out how to get it functioning together.... : (
On the crane, the provided piece that's meant to attach to the tripod is a flat plate with two bolts hanging off of it.
I'm getting frustrated with trying to figure out how to get it functioning together.... : (
Terry_Lasater
All about the Caption
Look at the item labeled "C" on this link: http://www.ezfx.com/Supports_&_Adaptors
Would that get you there? Do you have a 75mm or 100mm bowl?
Would that get you there? Do you have a 75mm or 100mm bowl?
Jay Rodriguez
Coffee Member
Just now looked at it...
That piece labled "C" has one threaded bolt sticking out of the top and in the center.
If that threaded bolt wasn't there but instead had two of them, one in the front and one in the back then it would be perfect......
Did you follow me on that?
That piece labled "C" has one threaded bolt sticking out of the top and in the center.
If that threaded bolt wasn't there but instead had two of them, one in the front and one in the back then it would be perfect......
Did you follow me on that?