AT4053B windscreen recommendation

Greg Smith

Veteran
I've just acquired a nice second-hand Audio-Technica AT4053b microphone and would like to know what others are using as a windscreen. It came with the usual little chunk'o'foam in the case, but I'm used to more robust solutions for my shotguns and wonder whether this mic needs the same degree of protection for typical indoor booming. Something lightweight and as visually unobtrusive as possible would be an advantage. It will usually be in a Rycote INV-7 lyre mount on the end of a K-Tek Avalon KE-110 pole.

Thanks.

- Greg
 
I did say "visually unobtrusive," right? :)

I'm sure that would greatly impress my University president the next time I walk into his office for an interview ... for probably the last time!

- Greg
 
I just use a cheap $5 foamy which 99.99% of the time is sufficient for interiors, boom swings and such. But I don't often use it in an exterior environment.
Otherwise the BBG or the lower cost/performance Windtech two stage US-2.
 
The K-Tek slip on fuzzy. It's a furry windscreen that works pretty well for exteriors in low to moderate wind. For interiors you can stick with the foam windscreen.
 
I have this EXACT question. I'm less concerned with wind that p-pos and plosives. Will the K-Tek be better at stopping those then the windscreen it came with? Or will it not make a difference in that regard?
 
I have this EXACT question. I'm less concerned with wind that p-pos and plosives.

I've never had a problem with plosives at all while booming, and I'm using a 4053b too. It would seem to me that you have to be a good bit closer than "normal booming position" to have that be a problem. Even then if you come in from the side and not directly in front it should be manageable.

In general, plosive control with condenser mics means pop filters. Probably I just don't understand the problem you are trying to solve though.
 
Ive been told to get about 6 inches away from someone's face when recording, and I find even if I am off center, they sometimes turn their head and I get pops.

Are there portable windscreens you can put on a mic?
 
Ive been told to get about 6 inches away from someone's face when recording, and I find even if I am off center, they sometimes turn their head and I get pops.

That's really close. I'm not sure why anyone would tell you to position a 4053b that close, but I have no doubt that there are reasons. I've just never needed to get so close in any of my work.

For me, my "normal" is with the mic in front of the talent and above the head, pointing down at the mouth at about a 45 degree angle. If the mic is out of the frame (and it should be) that puts it somewhere in the range of about 45-60cm away from the mouth. Hard to register a plosive from here, and the 4053b sounds great from this position with just the right amount of proximity effect giving talent's voice a nice warmth (men anyway, women somewhat less so as one would expect). And at this distance talent has some "wiggle room" making it difficult for seated talent to get out of pattern, even if they turn their head a fair amount. And yes, for a sit down interview I almost always use a c-stand, a boom pole, and a boom pole holder so the mic is static during the interview.
 
Back
Top