Any way to get H4n to work with 2 G2 lavs and work on left and right speakers?

[JoeJITSU]

When I hook up both the G2 lavs to XLR input 1 and 2 I get one on right side and one on left side but can't get both sides at the same time, is there any way to set this up correctly? THanks

 

[Alex H.]

Well, that's actually the way you should be recording. This gives you complete control over the mix in post. It's in editing that you will need to separate the stereo pair into separate, mono audio files, and then pan each to center.

 

[kgimedia]

Well, that's actually the way you should be recording. This gives you complete control over the mix in post. It's in editing that you will need to separate the stereo pair into separate, mono audio files, and then pan each to center.

+1

If for some reason you absolutely need a mono mix down of your audio your can go into the mixer section of the H4n menu and pan both to the left or right. I am fairly sure this will give you the effect you are looking for but my H4n is in my car right now and I am not going out in this heat so I can check this out.

 

[Captain Pierce]

If it's that hot, are you sure your H4n isn't just a little puddle of plastic on your car seat right now?