I have successfully, consistently gotten my MJPEG settings to give me
125megabit/s(~15.5MB/s) peaking to even over 160megabit/s (20MB/s) @ 720P/30FPS
on my Sandisk Extreme III 30MB/s card.
(Here is an example from a short clip I took)
Yet,
I cannot manage to get even a mere 40megabits/s in AVCHD mode.
I've used every patch there is out there for the GF1.
AVCHD at those higher rates almost always causes a card speed write error.
But why? If I can consistently record upwards of 160 megabit/s in MJPEG?
Is this just that no AVCHD patch has been quite perfected enough...
Perhaps due to the high amount of variables versus MJPEG's number of variables?
I apologize in advance if this is the wrong place for an inquiry of this type.
125megabit/s(~15.5MB/s) peaking to even over 160megabit/s (20MB/s) @ 720P/30FPS
on my Sandisk Extreme III 30MB/s card.
(Here is an example from a short clip I took)
Yet,
I cannot manage to get even a mere 40megabits/s in AVCHD mode.
I've used every patch there is out there for the GF1.
AVCHD at those higher rates almost always causes a card speed write error.
But why? If I can consistently record upwards of 160 megabit/s in MJPEG?
Is this just that no AVCHD patch has been quite perfected enough...
Perhaps due to the high amount of variables versus MJPEG's number of variables?
I apologize in advance if this is the wrong place for an inquiry of this type.
Last edited: