thartley
Veteran
I was just out getting some test footage with a new tape when I got the flashing red circle with an X on the LCD. Never had it before, but the manual says it means a dirty cylinder head.
1. Is the "cylinder head" the same as the recording head?
2. Previous to getting this test footage, I had accidentally left a tape in the camera for over a month. Could this be why I am getting this dirty head message on the LCD?
3. If the heads are dirty, will I get this message continuously? Or will that ugly circle flash intermittently? It went away after I shut the camera off and tried again a few minutes later.
When I first got the camera, I was using Sony tapes. I have since sent my camera in to an authorized service center for an overall cleaning, and a head cleaning specifically. I have only used AY-DVM63MQ since.
Thanks guys...
1. Is the "cylinder head" the same as the recording head?
2. Previous to getting this test footage, I had accidentally left a tape in the camera for over a month. Could this be why I am getting this dirty head message on the LCD?
3. If the heads are dirty, will I get this message continuously? Or will that ugly circle flash intermittently? It went away after I shut the camera off and tried again a few minutes later.
When I first got the camera, I was using Sony tapes. I have since sent my camera in to an authorized service center for an overall cleaning, and a head cleaning specifically. I have only used AY-DVM63MQ since.
Thanks guys...