puredrifting
Major Contributor
I totally agree Barry. Interesting that this DP happened to have been hired by both Sony and Panavision to shoot test material to promote the F35 and the Genesis, isn't it?
I always treat my P2 cards with kid gloves as far as always putting the rubber cap on and putting them in the case but it is reassuring to know that if I am ever in a rougher situation, the cards and the material will make it through intact.
Dan
I always treat my P2 cards with kid gloves as far as always putting the rubber cap on and putting them in the case but it is reassuring to know that if I am ever in a rougher situation, the cards and the material will make it through intact.
Dan
This is an utter load of crap though -- this is the stuff that Sony was saying in their booth at NAB 2007 that caused a few of us to blow a gasket.
I put this to the test -- I put a bare P2 card in my pocket, then I went to the casino cashier and got $10 worth of dimes and dumped 'em all in that same pocket. Then I wandered around the casino floor, swishing the card around with the change, trying to statify the hell out of it.
Then, since Sony was also telling people that magnetic interference from CRT monitors could cause a problem, I went to the CRT slot machines and rubbed the card all over the monitors, on the front, on the back, anywhere.
Then I walked through the entire convention center (still with that card, raw and bare, unprotected in a pocket full of dimes). Then I threw the card on the carpet and dragged it all over the carpet to work up as much static as I could.
Then I put the card in a camera. It played, just as perfectly as it did on day one.
Your DP friend has been victimized by a pack of lies courtesy of the Sony corporation.
And, curiously, they then released their own solid state media a few months later, and they specifically warn against static electricity and also against getting cell phones too near the cards! Ridiculous. Pathetic. And grossly irritating.