wind protection to fit both oktava and AT4073a

M

mccutch

Member
Okay. I'm a total newbie buying 2 Oktava MK012a's and 2 AT4073a's.

I've read on these forums i ought to get a Baby Ball Gag for the oktavas and at least a softie of fuzzy for the AT4073a.

Since I'm on limited funds, is there any kind of wind protection that would fit both my oktava and my At4073a? That way I could just move it from one to the other when i went from indoor to outdoor.

thanks,
 
They are totally different type and size of mic... the only way you could get one screen to fit both would be to get a full blimp that is sized for the 4073a and then fit the Oktava inside with lots of extra space OR you could get one of the new modular construction Rycote blimps and take a section off to size it down for the Oktava. I'd be surprised if you find a cheaper way to good windprotection then a Softie for the 4073a and a BBG on the Oktava.
 
if you not intend use the octava outside , you have nothing to match , use foam inside with octava , if you need it outside , use large foam from shure to work foam over foam , if it not enouth make fure to go over - frankly i dont see you need at all
 
the small rycot could not be extendeded only from 40 cn size ( the one which fit the 40 73)
 
You must log in or register to reply here.
Back
Top