timapter
Veteran
Hey all,
I need to get a cable made up for my SD302 that will allow it to sent a mic level signal into a Sony UWP-C1 transmitter. I want to use it as a pseudo-comtek for the drama I start on monday. We'll have three receivers that will be able to tune to that frequency..
I want to use the mix out (Ta3), and go into the sony which is on a minijack. Problem is that the mix out level is a hot signal ("fixed at its -15dBu nominal level" according to manual) and the sony only accepts mic level signals (because its crap).
What cable could I get made that would allow this interface to work? Im thinking a ta3f to dual minijacks (left and right - then I can choose which channel to send on coms, i dont want phasing and the Sony is obviously only mono)? Bit of an emergency this one, replies most welcome - Im an electrical idiot, so instructions I could give to the local cable man would be handy.
Cheers
I need to get a cable made up for my SD302 that will allow it to sent a mic level signal into a Sony UWP-C1 transmitter. I want to use it as a pseudo-comtek for the drama I start on monday. We'll have three receivers that will be able to tune to that frequency..
I want to use the mix out (Ta3), and go into the sony which is on a minijack. Problem is that the mix out level is a hot signal ("fixed at its -15dBu nominal level" according to manual) and the sony only accepts mic level signals (because its crap).
What cable could I get made that would allow this interface to work? Im thinking a ta3f to dual minijacks (left and right - then I can choose which channel to send on coms, i dont want phasing and the Sony is obviously only mono)? Bit of an emergency this one, replies most welcome - Im an electrical idiot, so instructions I could give to the local cable man would be handy.
Cheers