Tungsten to Daylight Gel + Lowel Pro Light 250watt

Gene Sung

Veteran
Hello,

I have a 3 part question.

1) I have a Lowel Pro Light (250watt Tungsten) which can go from flood to beam. I just got it and am planning to use it as a hair light with a snoot. If I put a blue daylight gel on it, how many stops will I lose? Since it's only a 250 watt light, after gelling, will it be sufficient to still use a hair light, or will it not emit enough light at that point.

2) I see that Roscoe Cingle and Lee both make gels. Is one better than the other? on B&H, the Lee's seem a bit less expensive.

3) On B&H, there are about dozens of different shades of blue in gels. Could someone pass me a link to the correct one? If not, could you tell me the exact name I should type in? Is it called "Full C.T. Blue?"

Thanks so much
 
Full CTB will cut you two stops, and everything else will cut it proportionally -- 1/2 CTB = one stop light loss, etc.

So, you'll have the equivalent of 63 watts once you gel it. Whether or not it's enough for a rim light depends on the look you're going for and how close it is to your subject.
 
Full CTB will cut you two stops, and everything else will cut it proportionally -- 1/2 CTB = one stop light loss, etc.

So, you'll have the equivalent of 63 watts once you gel it. Whether or not it's enough for a rim light depends on the look you're going for and how close it is to your subject.

I googled this and you're right! -- can't believe I've been operating under 3/4 = 3/4 for so long. Thanks for the correction David.
 
I have a dozen of these marvelous little lights and I use them, almost daily, gelled, for edge lights. With the camera set for daylight I start with 1/2 CTB and if we don't like the look of a little color in the backlight -- which can often be very attractive -- I add another layer and give 'em white light.

You're going to find your little light very versatile and you'll love how it fits anywhere.
 
Back
Top