TA5F to 2-channel 3-pin XLR cable?

[Alpha Flying Monkey]

I have a Wendt X3, and it has a TA5M output for Auxillary out:

"The AUX stereo output is unbalanced and is available on the 5 pin TA connector where pin 2 is RT and pin 4 is LT." (from the user manual)

So- I was thinking I would make a cable (TA5F to 2 x 3-pin XLRM), but if there's something like this available I might just spend the dough.

I found this one at B&H (But, it's $86.50!):
Lectrosonics TA5-F to Dual XLR Output Cable for SR Slot-In Receiver:
http://www.bhphotovideo.com/c/product/604137-REG

So, I figure if there isn't anything else out there more affordable I'm just going to have to solder that *#!% 5-pin TA5F.

 

[ZeroContent]

Soldering a TA5F isn't a huge deal. I've had to do it to wire lavs for lectros with a couple pins jumped with tiny 1k resistors. Have fun.

 

[Alpha Flying Monkey]

Oh, yeah- fun... I guess I'll just save up my soldering session for the TA5F to XLR3's & my 8-pin Neutricon breakaway cables... Oh, man- I can't wait! (No. Really.) :-KnockedOut(D

Soldering a TA5F isn't a huge deal. I've had to do it to wire lavs for lectros with a couple pins jumped with tiny 1k resistors. Have fun.