sound is a bit too much bass

It sounds Ok on my i-pad speaker so if it has too much bass on other speakers you need to add a high pass filter in your edit, I normally add a -24db high pass at 80hz for lav mics but if there is a lot of background traffic rumble then a 100-150hz filter may be needed! You can also do this on your mixer or some cameras have a high pass filter too!
 
What lav mic did you use ?

You need to use EQ to bring down frequencies from 300 hz and below, and as Gary stated adding a high pass filter at 80 hz will eliminate the low frequency rumble. I could also hear a lot of "snap-crackle-pop" in the high end that was coming from somewhere ? ( your music track ? )
 
the snap crakle pop was coming from the lav rubbing on my t-shirt.
I was using a rode lav.

Rick : how do you use some presence ?
Thanks to all for your answers. I will try it on Adobe Audition (if i have questions i will ask).
 
I always add some EQ at around 2.5-3.5khz to lav mics to give them presence and for live TV a little compression to out sony ECM 77b mics.
 
As Gary stated: a few dB (EQ) in that range would help.
BTW: What is with the music BG in a dialog demo?

Perhaps there is a language/terminology misunderstanding here as well with the OP?
 
i just added a song by a friend rapper to add a mood.
thanks for all the comments.
Have a good day !
 
You must log in or register to reply here.
Back
Top