Sibilance

Sad Max

Artful Dodger
So we were setting up tonight for tomorrow morning's shoot, and noticed that we were getting a lot of sibilance...

...we're going from a hypercardioid mic into a mixer into a limiter and back out into the DVXs' XLR input jacks. The mic is quality, and so is the other hardware; we've had good results using the same setup before. I tried changing the relationship of the mic axis to the speaker's mouth, tried changing out mics (another h-card and a lavalier), tried going directly into the DVX using phantom power (which these mics need) but the sibilance is still there...

Any advice? Alas I didn't not model number or mfgr info on the hardware before going home, but I assume that there's something basic we should be looking for, to corect this.

All input welcome and appreciated.
 
Last edited:
Sad Max,

I had a nice response below until I reread your post. In essence, from the perspective of troubleshooting what you're really saying:

1. My microphones and DVX have never had silibance problems
2. Now when I connect any of my existing mic directly to the DVX, I have silibance
3. Ergo, something is wrong with my DVX or its settings

Regards, Michael

-----
(prior thoughts before reread)
Sure sounds like a knob has been tweaked or something's not terminated/connected properly. Could the high band equalizer have been cranked up by someone? Or perhaps the limiter has a compressor that has the ratio cranked way up.

This should be easy to isolate. Did you detect sibilance on the mixer monitor using a *GOOD QUALITY* headset? (don't get fooled using a so-so headset as I once did and went off on a wild goose-chase elsewhere). If that's okay, bypass your limiter and recheck your DVX audio out (some have a bypass function button, too).
 
When I got back in the morning, it was reported that the problem had 'fixed itself.'

(Bob Hoskins voice)

Well, then, we don't need to do anything, do we? All you have to do is blow your nose, and everything's fixed!
 
Just for general info purposes, sometimes people mistake clipping with sibilance. Sibilance is usually associated with "ssss" sounds - somewhat like a sizzle and is noticed only when those type sounds are made. If you were getting distorted sounds on most sounds that weren't "sss" than you were getting clipping.

When you described the setup as going into a mixer & limiter and then into the DVX it made me wonder if you had the Dvx mic/line switch in the "mic" position. Too much mic pre gain or channel gain or too much high end EQ on the mixer could also have been the problem.

For future reference, sibilance is usually caused by either improper gain staging or improper EQ. Specifically, whoever is mixing needs to set the mic pre, EQ , and channel gain correctly.

Also, know the frequency characteristics of the mic you are using. Some mics have a high end boost that will promote sibilance.

Finally, distortion can also be caused if you aren't watching the DVX levels.

Since it went away in the morning it sure sounds like operator error on some setting or another. If you haven't found out what that error was, you should just so you know how to fix it if it happens again.

Ken
 
to add to those points - know your headphones!

i've been caught out with sibilance, thinking there's a huge problem when really it was just my headphones.

The actor was a very camp chap, so his sss's were very very ssssy indeed. I was really worried until I got home and listened on my monitors, and it sounded fine.
 
Back
Top