Easom Aerospace
Active member
Um Ya! Oops again and sorry if I missed a thread that covers this but I started a project and I'm a bit deep into it and its a widescreen project cause I shot with the widescreen bars on to clip the frame on the DVX. So my question is, I should have chosen the non wide project , so can I export an edl or something and re-open the project as a non wide with the same clips and effects and in out markers on the rubber bands and all? I sure hope so, but plese help if you can. The premiere help doesn't really say much other than you can only change a few of the project settings after starting. I did capture the footage using these project settings and it shows the black border around my footage. Is there a better way to capture dvx clipped wide footage and turn it into 16:9 ? Or will I be able to clip my end product and get rid of the border and render it out non squashed or do I need to start over now befor any more editing? Any help would be much appreciated. Thank you Thank you!
Cory
Cory
