lavalier how do you mitigate clothing noise?

Michael_Richard

Active member
I noticed that lavalier's pick up lots of clothing sounds, jewelry noises, etc when I do interviews. What are some preventive measures I can take to make sure I don't have this problem ?
 
Try this:

Try this:

Got a message in my email last week about these:

rycote_details_04.jpg


Rycote Undercovers
http://www.trewaudio.com/rycote_esale_details.htm
 
Interesting thisiswell. I had not seen those before. I might get an order for an experiment but I predict they are just an expensive replacement for Moleskin (Undercovers $24 for 30/Moleskin $5 for about 60 small pads). Only downside is I have to cut them myself. :)

Michael, clothing noise will always be an issue. I have seen 20 year veterans brought to tears from a stupid wardrode dept. If you have any control over wardrode avoid synthetic fibers. Also try some static free spray.

If you are not working on a fictional narrative, just leave the lav mic head on the outside of clothing, saves you a million headaches.

Good luck
 
take off the wind cover if its going to be under clothing inside. the little "softies" for wind can generate alot of excessive clothing rub noise.. tape the mic to the clothing using a solution such as above or gaffer tape or something thats not going to ruin clothing. if the mic is inbetween clothing layers tape it to both layers so that is sandwiched between them and taped to them making it and the clothing not move. be sure to make a loop with the wire to relieve tension and strain on the wire. then try to fasten any loose clothing around the mic or wire loop as wire rub noise can be a problem as well and tape the wire down by the loop. this should greatly reduce your clothing rub noise.


you can also put some tape on the talents shoes and eyebrows and possibly some over their ears.. when thats done be sure to tape their legs to the floor and tape some books to their head. then tape a pencil to their hand and tape some tape with tape in it in their hair. that should cover it. the general rule is that if you use a whole role of tape it will be fine.
 
in addition tho these helpful suggestions, a shotgun mic mounted just out of frame would provide a useful backup for interviews.
 
In the broadcast world we always use a lav and a boom split on two channels because inevitably the most important auido is always ruined with a lav when someone touches their chest. As for jewelry, ask them to take it off. Mic should be placed on the clip so that it does not touch the clothing but only the clip does. ANd todays clothing does make a bit of noise compared to years past.
 
Back
Top