TimothyJinx
Well-known member
Is the JVC TM910SU monitor sufficient for pulling focus with the RedRock M2?
If not, what would you fellas suggest?
If not, what would you fellas suggest?
JVC TM910 Sufficient for focusing with RedRock M2
- Thread starter TimothyJinx
- Start date
TimothyJinx
Well-known member
Anyone?
Maybe I should scan the RedRock forums.
Maybe I should scan the RedRock forums.
Owen
Photoshop Savant
I used it to pull for my last project after my VGA converter blew up half way through the shoot. I used the JVC and the HVX focus assist to double check my marks and the results were just as good as the ones I was getting off the HD monitor, though it took me a bit longer to check each setup and be sure I was good to go.
With only 300 lines of resolution I wouldn't recommend pulling focus JUST with that monitor, but if you also use the EVF detail and Focus Assist in addition you could get by.
You can be sure of this: if it looks out of focus on that monitor, it's definitely out of focus.
EDIT: I just realized this is the DVX section, so assuming you're shooting SD then I'd be 100% comfortable using that monitor for focus.
With only 300 lines of resolution I wouldn't recommend pulling focus JUST with that monitor, but if you also use the EVF detail and Focus Assist in addition you could get by.
You can be sure of this: if it looks out of focus on that monitor, it's definitely out of focus.
EDIT: I just realized this is the DVX section, so assuming you're shooting SD then I'd be 100% comfortable using that monitor for focus.