redshft
Member
I've recently started a job where I'm using a HMC150, a Canon 7D, and some ContourHD cameras. After completing a project and posting up on Youtube, we were a bit disappointed with the quality of a couple of clips...particularly in full screen. The clips in question were shot on the HMC150 at 720/60P and transferred into FCP in Prores codec.
The first clip seemed very pixelated and lo-res. It had a tilt-shift effect applied to it along with a gradient overlay. Although, after a test of removing the filter and overlay, exporting in H.264 via Compressor, and uploading to Youtube, the clip is still very poor quality. Other clips from the HMC look fine while just these 2 or 3 don't. Is this just an issue with the camera's video being compressed to Youtube?
The two other clips we noticed were both under the same location with same lighting. Very dark with with an Arrilite 1000 and 650 lighting up the cars on a turn table. The issue with these are again, very pixelated lines along the body of the cars, as well as a jerky movement with one of the cars as it spins on the turn table.
I've used a Sony HVR-Z1U and Canon 7D in the past and have never had this issue. It's really got me baffled and a frustrated right now as this was my first project.
These issues are most noticeable under full screen and not so much with the regular size. I understand that full screen will make the compression woes stand out a bit more, but this is a bit much. Any help would be greatly appreciated.
Thanks
The first clip seemed very pixelated and lo-res. It had a tilt-shift effect applied to it along with a gradient overlay. Although, after a test of removing the filter and overlay, exporting in H.264 via Compressor, and uploading to Youtube, the clip is still very poor quality. Other clips from the HMC look fine while just these 2 or 3 don't. Is this just an issue with the camera's video being compressed to Youtube?
The two other clips we noticed were both under the same location with same lighting. Very dark with with an Arrilite 1000 and 650 lighting up the cars on a turn table. The issue with these are again, very pixelated lines along the body of the cars, as well as a jerky movement with one of the cars as it spins on the turn table.
I've used a Sony HVR-Z1U and Canon 7D in the past and have never had this issue. It's really got me baffled and a frustrated right now as this was my first project.
These issues are most noticeable under full screen and not so much with the regular size. I understand that full screen will make the compression woes stand out a bit more, but this is a bit much. Any help would be greatly appreciated.
Thanks