HELP! Print to Tape in FCP using the DVX100A

[Throneofblood]

I shot my film originally on a P2 card from the Panasonic HVX200 cam, and I am having problems printing to tape from Final Cut Pro 5 to my Panasonic DVX100A cam. I have audio, but no video. I tried exporting to a QT, but even still, when I open the QT back up in FCP, I have audio and no video.

My settings are as follows:
Sequence Preset: DV NTSC 48 kHz
Capture Preset: DV NTSC 48 kHz
Device Control Preset: Firewire NTSC
Video Playback: Apple Firewire NTSC (720x480)
Audio Playback: Firewire DV

I have refreshed my A/V Devices, and in my camera I have played with many configurations and settings with the 1394.

The strange thing is when I move my cursor over my sequence, I get a still image in my camcorder viewer. However, when I try to play it, it freezes on that one frame, while the sequence runs.

I don't know if it's possible to record a 24 signal (from the original 720p P2 card) to an NTSC tape via Firewire, or if the DVX100A will only write 24pa to tape while it is shooting.

Any suggestions? I am running out of solutions.

 

[CamVega]

I'm having the same issue.
My footage was shot on an HVX to tape, I was able to print to tape a few months ago from the same project. As far as I know I haven't changed any settings.
Since that time however... my logic board has been replaced, and I've upgraded my HVX's firmware.

I'd really like to hear some suggestions before I try reformatting. =/