Marc Lucas
Active member
Been using the Ghost for a couple of years and been fine.
Recently I've tried to power up the gimbal and when I do the whole thing shakes and goes a little weird. The status green LED on the back panel is flashing at this point.
I've tried to connect to the SimpleBGC software to see if what happening there and when it did connect (briefly) there were a number of errors including the sensor not being connected.
Whats an easy fix if there is one or is there a way to completely set the gimbal to a default state and then I can use the SimpleBGC software presets to setup the gimbal again. I've contacted SIC but Jesse hasn't got back to me yet.
Thanks in advance.
Recently I've tried to power up the gimbal and when I do the whole thing shakes and goes a little weird. The status green LED on the back panel is flashing at this point.
I've tried to connect to the SimpleBGC software to see if what happening there and when it did connect (briefly) there were a number of errors including the sensor not being connected.
Whats an easy fix if there is one or is there a way to completely set the gimbal to a default state and then I can use the SimpleBGC software presets to setup the gimbal again. I've contacted SIC but Jesse hasn't got back to me yet.
Thanks in advance.