FCP = "Mastering To Tape"

S

SGFilms

Well-known member
When using my Media100 to export/master to tape, I go to "Master to Tape" and click OK.

I never did this while using FCP and I'm trying to export footage that is on my timeline to the camera (DVX100). Can anyone help me with this? I want to make it so it shows up on the camera and where I can record it onto tape from the DVX (top of it where you can press play/record at the same time and record on the tape)
 
And when I tried to press record/play or record on the top of the DVX, it wouldn't record. Not sure if it's the camera or if the upload is actually being recorded without the camera stating it....anyone know if thats the case?
 
Give me an "The end of tape has been enountered".... I had put about 14 minutes of Black Code on it as stated in one of the tutorials. Anyone know what the issue may be? Should I put in a blank tape without the Black Code on it?
 
Black and Coding only works with decks that allow you to INSERT edit...and do to that you need to use the EDIT TO TAPE option. But if your are outputting back to the camera, then you will use the PRINT TO VIDEO option, and that really only allows you to press RECORD on the camera and go what is known as an ASSEMBLE edit.

Unsure why your camera is acting that way though...
 
You must log in or register to reply here.
Back
Top