I have a friend who has asked me to pull some footage from tapes on his FX1. For some reason, whenever I try to use a prores codec, it hangs FCP completely after several minutes of transferring. If I switch it over to HDV/AIC, everything captures fine.
I've tried many of the common things including:
- Trashing the prefs
- Creating a new admin user and trying that user
- Changing to a different scratch drive
- Repairing permissions
Basically everything I can think of has been attempted. I have noticed that it seems to hang in approximately the same place each time. That said, I can capture just fine through that same piece of tape with a different codec. Im at a loss on this one. I'm planning to try a different firewire cable next but it's the same cable that's reliably capturing it to AIC.
Any ideas? Maybe my Prores settings need tweaked? All of the source footage is 1080i.
I've tried many of the common things including:
- Trashing the prefs
- Creating a new admin user and trying that user
- Changing to a different scratch drive
- Repairing permissions
Basically everything I can think of has been attempted. I have noticed that it seems to hang in approximately the same place each time. That said, I can capture just fine through that same piece of tape with a different codec. Im at a loss on this one. I'm planning to try a different firewire cable next but it's the same cable that's reliably capturing it to AIC.
Any ideas? Maybe my Prores settings need tweaked? All of the source footage is 1080i.