GND
Well-known member
I finished a short film: done in 24pA / squeeze mode
Everything plays perfectly in FCP and in the quicktime movie I exported it as.
so I sent it into iDVD (all I have - but I've burned 4 films in the past with the same settings and have had no problem) and burned it...
when I played the DVD back on my TV set - between every cut there is a 1 frame flash of black. It's very annoying....well, one mistake like that isn't acceptable but especially during scenes with a few quick cuts every 5 or so frames...it's like the movie is flashing (Like I intended it to have a flashing effect as if lights being turned off + on).
what could this problem be? something in the export? or should I just try and burn again and hope it doesn't do that?
...but it takes my a couple hours to burn as my CPU sucks lately...so I'd like to be sure of it first.
Everything plays perfectly in FCP and in the quicktime movie I exported it as.
so I sent it into iDVD (all I have - but I've burned 4 films in the past with the same settings and have had no problem) and burned it...
when I played the DVD back on my TV set - between every cut there is a 1 frame flash of black. It's very annoying....well, one mistake like that isn't acceptable but especially during scenes with a few quick cuts every 5 or so frames...it's like the movie is flashing (Like I intended it to have a flashing effect as if lights being turned off + on).
what could this problem be? something in the export? or should I just try and burn again and hope it doesn't do that?
...but it takes my a couple hours to burn as my CPU sucks lately...so I'd like to be sure of it first.